Material-efficient Cu wire-based 3D printing technology

Area Acceleration (D2) Segment Upscaling (D2.2) Duration 2019/01/01-2021/12/31

Additive Manufacturing Meeting 28 listopada 2019

Date: 18-19 September, 2019

Place: Wrocław, Poland

Our colleagues had a chance to take part in the Additive Manufacturing Meeting in Wrocław. This event was an international conference for additive technologies users. The aim of it was creating a platform for sharing knowledge and experience in 3D printing. During this event the results of the tests conducted as part of the project were shown.

Project Partners

Łukasiewicz Research Network - Institute of Non-Ferrous Metals

  • Development of the Cu-based alloys
  • Development of production technology of feedstock materials for WAAM
  • Wire arc additive manufacturing at laboratory scale
  • Materials investigations

Ghent University

  • Corrosion-fatigue investigations
  • Tests of the prototypes in seawater environment
  • Educational activities

Italian National Agency for New Technologies, Energy and Sustainable Economic Development

  • Material investigations
  • Mechanical proporties

Gefertec GmbH

  • Development of the production process parameters by means of 3DMP technology
  • Implementation of the results of the project (end user)
  • Manufacturing of the new products

Tecnalia Research and Innovation

  • Erosion tests
  • Non-destructive tests

Supported by

2019 © Material-efficient Cu wire-based 3D printing technology | All rights reserved
Agencja Interaktywna ITOWN - profesjonalne strony www