Material-efficient Cu wire-based 3D printing technology

Area Acceleration (D2) Segment Upscaling (D2.2) Duration 2019/01/01-2021/12/31

The First European Conference on Structural Integrity of Additively Manufactured Materials 12 września 2019

Date: 9-11 September, 2019

Place: Trondheim, Norway

From the 9th to the 11th of September Joanna Kulasa and Aleksander Kowalski took part in The First European Conference on Structural Integrity of Additively Manufactured Materials (ESIAM19) in Trondheim.

The physical phenomena of fatigue and fracture of AM materials as well as 3D printing were discussed widely. The conference was also a great opportunity for extensive networking, and promoting the project in a poster session.

Project Partners

Łukasiewicz Research Network - Institute of Non-Ferrous Metals

  • Development of the Cu-based alloys
  • Development of production technology of feedstock materials for WAAM
  • Wire arc additive manufacturing at laboratory scale
  • Materials investigations

Ghent University

  • Corrosion-fatigue investigations
  • Tests of the prototypes in seawater environment
  • Educational activities

Italian National Agency for New Technologies, Energy and Sustainable Economic Development

  • Material investigations
  • Mechanical proporties

Gefertec GmbH

  • Development of the production process parameters by means of 3DMP technology
  • Implementation of the results of the project (end user)
  • Manufacturing of the new products

Tecnalia Research and Innovation

  • Erosion tests
  • Non-destructive tests

Supported by

2019 © Material-efficient Cu wire-based 3D printing technology | All rights reserved
Agencja Interaktywna ITOWN - profesjonalne strony www